Ultra-start 25XX Series Manual de usuario descargar pdf (Pagina 15)

Quick View Programming

* See the following pages for more detailed programming instructions.

Menu 1 - Press Lock 1 Flash 2 Flashes 3 Flashes

1 Ignition Lock Enabled Lock Only Disabled

2 Siren Chirp Type 1 Type 2 All Chirps

3 Lock&Unlock Options Double Unlock 3 second .75 second

4 Unlock/Disarm 125ms 750ms

5. Passive Locks Enable Disable

6. Shock Sensor Disable Enable

7. Passive Arming Type 1 Type 2 Disable

8. Auxiliary Outputs Type 1 Type 2 Disable

Menu 2 -Press Unlock 1 Flash 2 Flashes 3 Flashes

1 Secure Service Mode 15 seconds 5 seconds

2 Park Light Output 30 seconds (-) Park Light Light Flash

3 Horn Timing 5ms 50ms 10ms

4 # Button Trunk Release Garage Door Car Finder

5 Reservation Mode Manual Auto Reservation- Manual Models

Menu 3 -Press Start 1 Flash 2 Flashes 3 Flashes

1 Lock/ Unlock Type Type 1 Type 2 Normal

2 Gas/ Diesel Negative 15 second Gas/ Positive

3 Rearm Output Type 1 Type 2 Rearm

4 Run Time 4 Min 45 Min 15 Min

5 Crank Time 10 seconds 3 seconds 5 seconds

6 Starter Disable/GWR Active Passive GWR

7 Safety Start Mode Press twice Press once

8 Programmable Input (+) Instant Start (+) Disconnect

Menu 4 -Press # 1 Flash 2 Flashes 3 Flashes

1 Low Idle Learn Low Idle Learn

2 Adjust For Over Crank Reduced by 10%

3 Adjust For under Crank Increased by 10%

**Bold type indicates settings that are Factory Default.

Page 15

REMOTE VEHICLE STARTER/ALARM INSTALLATION MANUAL

System Reset

The system reset will clear any changes made to the Program Menu’s as well as the

Tach setting. When the system reset is complete the system must be Tach learned

before the remote starter will operate.

1) Turn the ignition key from “Off” to “On” 3 times, ON-OFF-ON-OFF-ON within three

seconds. (Leave the key in the ON position)

2) Press and release the Program Button located on the antenna. The park lights will

turn on and the siren will chirp one time.

3) Then press and hold the Program Button until the park lights flash and the siren

will chirp 3 times slowly to confirm system reset.

System is now reset to factory defaults.

Note: System Reset does not delete the transmitter codes from memory.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comentarios a estos manuales

Sin comentarios

Ultra-start 25XX Series Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Ultra-start 25XX Series