Ultra Start 33xx Series Guía de instalación descargar pdf (Pagina 15)

Menu 1 - Press 1 Flash 2 Flashes 3 Flashes

1 Ignition Lock Enabled Lock Only Disabled

2 Horn Honk Type 1 Type 2 All Honks

3 Lock&Unlock Options Double Unlock 3 second 3/4 second

4 Unlock/Disarm 125ms 750ms

Menu 2 -Press 1 Flash 2 Flashes 3 Flashes

1 Secure Service Mode 15 seconds 5 seconds

2 Park Light Output 30 seconds (-) Park Light (+)Park Light

3 Horn Timing 5ms 50ms 10ms

4 Button #4 ( Button) N/A N/A Car Finder

5 Reservation Mode Manual Auto Reservation

Menu 3 -Press 1 Flash 2 Flashes 3 Flashes

1 Lock/ Unlock Type Type 1 Type 2 Normal

2 Gas/ Diesel Negative 15 second Gas/Positive

3 Rearm Output Type 1 Type 2 Rearm

4 Run Time 4 Min 45 Min 15 Min

5 Crank Time 10 seconds 3 seconds 5 seconds

6 Starter Disable/GWR Active Passive GWR

Menu 4 -Press 1 Flash 2 Flashes 3 Flashes

1 Low Idle Learn Low Idle Learn

2 Adjust For Over Crank Reduced by 10%

3 Adjust For under Crank Increased by 10%

**Bold type indicates settings that are Factory Default.

System Reset

The system reset will clear any changes made to the Program Menu’s as well

as the Tach setting. When the system reset is complete the system must be

Tach learned before the remote starter will operate.

1) Turn the ignition key from “Off” to “On” 3 times, ON-OFF-ON-OFF-ON within

three seconds. (Leave the key in the ON position)

2) Press and release the Program Button located on the antenna. The park

lights will turn on and the horn (optional) will honk one time.

3) Then press and hold the Program Button until the park lights flash and the

horn (optional) will honk 3 times slowly to confirm system reset.

System is now reset to factory defaults.

NOTE: System Reset does not delete the transmitter codes from memory.

* See the following pages for more detailed programming instructions.

REMOTE VEHICLE STARTER INSTALL MANUAL

PAGE 15

Quick View Programming

Ultra Start 33xx Series Guía de instalación Pagina 15