Ultra Start 33xx Series Guía de instalación descargar pdf (Pagina 8)

Wiring Descriptions

MAIN CONNECTOR (6pin)

Pin Function Description

1-YELLOW Starter Output - This wire will test 0V in OFF, ACCESSORY and in

the ON key positions. 12v during START ONLY.

2-GREEN Heater/Acc Output - This wire will test 0V in the OFF and START

key positions. 12-14V in the ACCESSORY

and RUN key positions.

3-RED 12volt Input(30amp) - Supplies 12votls for the IGNITION, PARK

LIGHT and SELECTABLE outputs.

4-RED 12volt Input(30amp) - Supplies 12 volts for ACCESSORY and

STARTER outputs.

5-BLUE Ignition Output - This wire will test 0V in the OFF and

ACCESSORY key positions.12V in the

IGNITION, START and RUN positions.

6-WHITE Selectable Output - Output for 2nd IGNITION, 2nd ACCESSORY

or 2nd STARTER.

AUXILIARY CONNECTOR (14pin)

Pin Function Description

1-YELLOW Re-arm(-) - 0.75 second pulse output when is pressed and after

remote start shutdown.

Used for factory alarm re-arm. (Menu 3)

2-RED/ Trunk Release(-) - Programmable output. Hold or button

WHITE for 3 seconds, output will stay active

(max 5 seconds) or (-)park light.

3-BROWN Dis-arm(-) - 0.75 second pulse when and is pressed and before

remote starter activation. Used for factory alarm dis-arm.

4-ORANGE Ground When Running(-) - Output active during remote start.

/Starter Kill Programmable Starter Kill. (Menu 3)

5-WHITE/ Horn(-) - Output to activate factory horn. (Menu 1&2)

BLUE

6-BLACK/ Parking Brake(-) - Input to detect (-) when parking brake switch

WHITE is applied. (“M” series)

7-PURPLE Door Pin(+) - Input to detect 12v when door is open. (“M” series)

8-WHITE Park Light(+) - 10amp positive output to activate park lights.

Programmable output (menu 2)

INSTALL MANUAL REMOTE VEHICLE STARTER

PAGE 8

Ultra Start 33xx Series Guía de instalación Pagina 8