Ultra Start 33xx Series Guía de instalación descargar pdf (Pagina 7)

ACTIVE RF ANTENNA**

1 2

NOTE: The jumpers control the output from the WHITE wire on the

main 6- pin harness. This is an 30amp relayed output.

*The factory default setting of the Selectable Output jumper is position #3.

Output on White wire Jumper position

Second Starter Position 1

Second Accessory Position 2

Second Ignition Position 3

Status Led’s

Program Button

**The antenna MUST be connected for the system to operate

*The centre pin of the keyless entry harness is ONLY available with plug-in

devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.

Overloading this output will damage the remote starter.

Jumpers

Wiring Diagram

REMOTE VEHICLE STARTER INSTALL MANUAL

PAGE 7

GREEN

WHITE/VIOLET

RED*

BLACK

BLUE

RED

Door Lock Output (-)250ma

Ground While Running Output (-)250ma

12v Output (+)250ma (see notes above)*

Ground Output (-)250ma

Door Unlock Output (-)250ma

12Volt Output (+)250ma

(-) Input Trigger (13xx Series Only)

NOTE: The 2 pin white and 3 pin white auxiliary connectors are not

available on the 32xx series.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sin comentarios

Ultra Start 33xx Series Guía de instalación Pagina 7